VCPN610 試験問題を無料オンラインアクセス

Which statement is true regarding deploying NSX over a physical network?

• A.NSX can implement IPv6 on an IPv4 physical network.
• B.OSPF can be used for Management traffic in a Layer 3 fabric design.
• C.Routing is supported on bridged interfaces.
• D.VLANs are not required to separate traffic between virtual machines.

You are tasked with designing a data center architecture that should maximize the use of vMotion within your environment. You must use these VMware best practices:
- The network must utilize widely offered layer 2 switching and layer 3 switching services - Purchase of new equipment should be minimized
Which two network design architectures will provide the requirements for vMotion in your data center? (Choose two.)

• A.Employ layer 2 multipathing using a standardized protocol.
• B.Utilize layer 3 switching from the access layer through the core.
• C.Deploy an overlay technology for the deployment of your virtual network.
• D.Deploy a flat, traditional layer 2 switched network.

A Distributed Router and an NSX Edge Gateway are connected to a Logical Switch with a VNI of 7321. Both also have connections to the external network.The Distributed Router serves as the default gateway for the virtual machines in VNI 7321.
A vSphere administrator does not want to advertise the subnet in VNI 7321 to the rest of the network, but still wants to allow virtual machines in the segment to access external resources.
What two steps should the vSphere administrator take to achieve this? (Choose two)

• A.Create an inbound Access Control List on the Distributed Router.
• B.Make the NSX Edge Gateway the default gateway for VNI 7321.
• C.Configure a static route to the NSX Edge Gateway in the upstream router.
• D.Configure a SNAT rule for VNI 7321 on the NSX Edge Gateway.

What is the function of NSX Data Security?

• A.Identifies sensitive data in your virtualized environment based upon regulation security policies
• B.Prevents sensitive data in your virtualized environment from being copied
• C.Identifies sensitive data in your virtualized environment based upon regulation violation reports
• D.Prevents sensitive data in your virtualized environment from being modified

What is determined when an NSX Administrator creates a Segment ID Pool?

• A.The range of VXLAN Network Identifiers (VNIs) that can be assigned to Logical Switches.
• B.The total number of addresses that can be used to assign VTEP IP addresses to ESXi hosts during host preparation.
• C.The total number of Logical Switches that can be deployed in a single Compute Cluster.
• D.The range of VLAN segments that can be assigned to Transport Zones.