VCP550 試験問題を無料オンラインアクセス

The Edit Settings wizard reports a virtual machine is configured as follows: -- Exhibit -

-- Exhibit -
Which setting, if NOT configured, will prevent network connectivity?

• A.The MAC address must be supplied.
• B.The DirectPath I/O status must be Supported.
• C.The device status must be set to Connected.
• D.The network label must be supplied.

-- Exhibit --- Exhibit -

The vCenter Operations Manager dashboard shows Health issues associated with the selected virtual machine. There have been no availability or configuration issues associated with the virtual machine, and the workload badge is still green.
What is the most likely reason for this health score?

• A.The workload for the virtual machine is higher than normal, which is generating a large number of anomalies within vCenter Operations Manager.
• B.A recent migration to another host in the cluster has violated HA admission control policy.
• C.A high stress and a pattern of constrained resources has been attributed to the virtual machine in vCenter Operations Manager.
• D.vCenter Operations Manager has determined that the time remaining for the virtual machine's assigned CPU resources is very low.

A SAN administrator recently installed a storage encryption switch on the Fibre Channel Fabric. Shortly after the deployment, several new VMFS5 datastores recently created were dismounted. Attempts to manually mount them fail. VMFS5 upgraded datastores are unaffected. All Storage arrays in use support VASA and VAAI.
What is the root cause of this problem?

• A.All newly created VMFS5 datastores were formatted with 1MB block size. The storage encryption switch does not support this block size.
• B.All newly created VMFS5 datastores are tagged ATS_Only. The storage encryption switch blocks the ATS command.
• C.All newly created VMFS5 datastores are tagged WRITE_SAME_Only. The storage encryption switch blocks the WRITE_SAME command.
• D.All newly created VMFS5 datastores are tagged XCOPY_Only. The storage encryption switch blocks the XCOPY command.

Which statement is true about the hardware configuration for ESXi hosts participating in a virtual SAN?

• A.The hosts must have network attached storage.
• B.Each host must have a RAID Controller.
• C.The hosts must have identical hardware.
• D.Each host must have at least one Solid State Drive (SSD).

-- Exhibit -

-- Exhibit -
The vSphere administrator needs to remove the Production virtual machine port group from an ESXi host. The ESXi host's Networking Configuration tab is shown in the exhibit.
After disconnecting the Fileserver02 VM, what step does the administrator need to take, assuming that vSwitch1 will still be needed for further configuration?

• A.Remove the Production port group by accessing the properties for the port group.
• B.Remove the Production port group by accessing the properties for the Network.
• C.Remove the Production port group by removing vSwitch1.
• D.Remove the Production port group by accessing the properties for vSwitch1.