2V0-620 試験問題を無料オンラインアクセス

What differentiates a private cloud from a vSphere Infrastructure?

• A.vSphere Infrastructure allows consumption of resources over open standards.
• B.vSphere Infrastructure assumes a secure location for the workloads.
• C.A private cloud requires pooled resources including storage and networking.
• D.A private cloud assumes the consumer will maintain their portion of the infrastructure.

An administrator has been tasked with upgrading an existing host from ESX 4.1 to ESXi
6.x. The existing host has only vSwitch0 with all the default settings.
The upgraded host will have the following new requirements:
1 . 116 virtual machines will be connected.
2 . Four uplinks configured for port-based load balancing.
3 . The switch will include a secondary heartbeat network for HA.
Which two statements are true about this configuration? (Choose two.)

• A.The Service Console Port will be removed during the upgrade
• B.A change to vSwitch0 Properties is required
• C.The configuration requires only one VMkernel Port
• D.The default vSwitch0 is sufficient for this configuration

An administrator must determine an appropriate backup solution, given these conditions:
* 50 of the virtual machines are in a resource pool named Finance.
* 50 of the virtual machines are in a resource pool named QA.
Which solution allows an administrator the ability to backup 100 virtual machines?

• A.Use the VMware Data Protection (VDP) Appliance on one of the ESXi Hosts to backup the virtual machines.
• B.Use Snapshot Manager on the vCenter Server to backup the virtual machines.
• C.Use the VMware Consolidated Backup (vcb) tool on the ESXi Host to backup the virtual machines.
• D.Use the VMware Data Recovery (VDR) Appliance on the vCenter Server to backup the virtual machines.

An administrator needs to monitor traffic on vSwitches in a vSphere 6.x environment.
Which option, if configured, would accomplish this task?

• A.Notify Switches
• B.Promiscuous Mode
• C.MAC Address Changes
• D.Forged Transmits

An administrator has just configured the IP address on an ESXi host from the Direct
Console User Interface.
How can the configuration be validated as correct without any additional tools?

• A.Use PowerCLI to connect to the host and initiate a network test.
• B.Connect to the host with the vSphere Client and click the Test Network option.
• C.Select the Test Management Network option from the DCUI.
• D.Add the host to vCenter Server and if it works, then all networking settings are ok.