SMI300XS 試験問題を無料オンラインアクセス

Before reinstalling the motherboard tray, what critical step should be taken to ensure proper installation?

• A.Screw in the motherboard tray at random points before aligning it
• B.Shake the tray to confirm it fits properly
• C.Tilt the motherboard tray at an angle before placing it
• D.Align the motherboard tray with the grooves in the chassis

Once you have removed all 12 screws that secure the motherboard to the motherboard tray, what is the proper way to remove the motherboard?

• A.Avoid touching the pins and carefully slide the motherboard slightly out of the rear of the tray, then place one hand underneath the rear of the tray and continue sliding the motherboard out of the tray without tilting it up or down.
• B.Tilt the chassis to shake it out of the tray.
• C.Use one hand the entire time to remove the motherboard tray and hold the motherboard in the bottom center as if you're holding a pizza.
• D.Make sure to touch the pins and shove the motherboard out of the tray.

When lowering the midplane bracket back into the chassis, what should you make sure to do with all the cables?

• A.Move only the power cable out of the way as you lower the bracket.
• B.Move only the I2C cable out of the way as you lower the bracket.
• C.Move all the cables out of the way as you lower the bracket.
• D.Move only the ribbon cable out of the way as you lower the bracket.

As shown in the video, when returning any tray (GPU, motherboard, PCIe) back to the chassis, why must you screw in a tray at one end of the chassis first, before installing another tray at the opposite end of the chassis?

• A.Because the tray will not function.
• B.Because the tray will get pushed out.
• C.Because the tray will break.
• D.Because the cables in the tray will get in the way.

Before disconnecting the cables from the NVMe backplane, what precaution should be taken?

• A.Randomly disconnect cables and reconnect them later.
• B.Disconnect the power supply first.
• C.Shake the system to loosen cables before disconnecting them.
• D.Map the cables so that you can reconnect them to the proper port location later on.