E_S4CON_2505 試験問題を無料オンラインアクセス

You are performing an SAP S/4HANA conversion with the migration repetition option. After which phase does SUM stop to enable a test cycle?

• A.EU CLONE MIG_DT_RUN
• B.EU_CLONE MIG SOT RUN
• C.EU IMPORT ALL
• D.EU_CLONE MIG_DT_CREATTE

Which preoperational steps must be performed for an SAP S/4HANA conversion? Note: There are 2 correct answers to this question.

• A.Uninstall SAP Fiori apps NO T released for SAP_UI 7.50.
• B.Delete client 066 (Early-Watch client).
• C.Install add-on SAP Gateway 7.50.
• D.Perform the custom code adjustment.

What do you need to know about the SAP S/4HANA Conversion Guide? Note: There are 2 correct answers to this question.

• A.It explains the database migration option (DMO) of SUM.
• B.It explains where to find information about the custom code analysis.
• C.It contains a section about the simplification item (SI) checks.
• D.It is a operating system-specific document.

You are running an SAP ECC system with SAP BASIS 740, non-Unicode on SAP MaxDB. Which of the following are possible paths to perform an SAP S/4HANA conversion? Note: There are 3 correct answers to this question.

• A.
• B.
• C.
• D.
• E.

What do you need to consider when performing the SI checks for an SAP S/4HANA conversion? Note: There are 2 correct answers to this question.

• A.You need an SAP system based on AS ABAP 7.52 or above for the SI check framework.
• B.The errors from the SI checks must be solved; otherwise, SUM will report an error.
• C.The Si checks are executed in the development system and the results are transported into the subsequent systems.
• D.You need to build up an SI check framework by applying SAP Notes.