C_IBP_2005 試験問題を無料オンラインアクセス

You have set up a planning area and data is available. You adjust the necessary time profile settings and run the consistency check.
Which settings can you change and still run a successful consistency check?
There are 2 correct answers to this question.
Response:

• A.Remove an attribute assigned to the time profile level if the attribute is used in a planning level.
• B.Change the past and future horizon of the levels in the time profile.
• C.Change the description of the attributes in a time profile.
• D.Add a new time profile level to the time profile.

You model the following supply chain:
- A finished product is manufactured on 2 different packaging lines
- Production takes place for 40 % on line A. 60 % on line which varies over time
- Produced products are immediately shipped to two warehouses, respecting the required minimum safely stock values
- One warehouse is temporarily closed sometime during the next three months.
Which sourcing rules do you use?
There are 2 correct answers to this question.
Response:

• A.P-rule
• B.T-rule, time dependent
• C.U-rule
• D.T-rule, time independent

Which objects can you query on in the Advanced Analytics application?
There are 2 correct answers to this question.
Response:

• A.On all versions
• B.On simulations
• C.Only on the base version
• D.On scenarios

What are some of the prerequisites for configuring a planning area that results in a successful consistency check?
There are 2 correct answers to this question.
Response:

• A.Configure at most two input key figures on the same planning level in a key figure calculation.
• B.Configure at least one calculated key figure for the planning area.
• C.Assignment of a compound master data type necessitates the assignment of its component master data types too.
• D.Specify a planning horizon in the planning area for each level of the assigned time profile.

Which conditions are prerequisites for key figure disaggregation?
Please choose the correct answer.
Response:

• A.The key figure is set to Not Editable.
• B.The calculated key figure is available and aggregation mode is selected.
• C.The key figure is stored and editable in the current and future.
• D.The key figure is calculated and editable in the current and future.