C-TS422-2504 試験問題を無料オンラインアクセス

Where does the system check master data selection settings during the creation of planned orders production orders? Note: There are 3 correct answers to this question.

• A.In the bill of material (BOM)
• B.In the MRP controller
• C.In the work centers
• D.In the routing
• E.In the production version

Which time elements are relevant for lead time scheduling of a production order? Note: There are 2 correct answers to this question.

• A.Setup time
• B.Total replenishment lead time
• C.Float after production
• D.Opening period

Why would you use phantom assemblies?
Note: There are 3 correct answers to this question.

• A.To increase the number of planning levels
• B.To reduce the number of changes required in bills of material
• C.To reduce the number of material masters
• D.To simplify the structure of bills of material
• E.To make the assignment of components easier

How would you define pegging in the context of Advanced Planning?

• A.An evaluation that is ordered according to the network structure of all related products represents the coverage of issue elements with receipt elements stock
• B.An evaluation to identify material or capacity shortages in the billofmaterial structure after the production planning run
• C.An evaluation that is ordered according to the billofmaterial structure of all related products represents the relationship between the receipt the issue elements
• D.An evaluation to identify overstock situations in the balance between the receipt the issue elements after the production planning run

Why do you use Engineering Change Management? Note: There are 2 correct answers to this question.

• A.To save multiple changes for an object
• B.To monitor document object changes
• C.To enable integration into a sales order
• D.To monitor document table changes