C-IBP-2305 試験問題を無料オンラインアクセス

Which of the following data can be tracked using a change-history-enabled key figure?Note: There are 3 correct answers to this question.

• A.Modified date
• B.Scenario ID
• C.Key figure type
• D.Reason code
• E.Attributes

You have set up a planning area, and data is now available. You adjust the necessary time profile settings and run a consistency check.Which settings can you change and still run a successful consistency check?Note:
There are 2 correct answers to this question.

• A.Change the past and future horizon of the levels in the time profile.
• B.Change the description of the attributes in the time profile.
• C.Add a new time profile level to the time profile.
• D.Change the numbering hierarchy of the period IDs in the time profile.

Which of the following data inputs, when increased, will always cause an increase in the safety stock outputs when the Global (multi-stage) Inventory Optimization operator is run?Note: There are 2 correct answers to this question.

• A.Holding Cost Percentage
• B.Target Service Level
• C.Transportation Lead Time Error CV
• D.Minimum Lot Size

Which of the following checks for master data and key figures does the Check Mode algorithm trigger?Note:
There are 3 correct answers to this question.

• A.It checks whether the location products specified in the master data are connected by customer sourcing rules within the supply chain network.
• B.It checks whether the heuristic detects cycles formed by nodes (such as location products) in the supply chain network.
• C.It checks whether the sourcing in the Production Source Item Master Data type exists.
• D.It checks whether the location resource specified in the master data forms a cycle in the supply chain network.
• E.It checks whether the required planning level master data exists for a subset of input key figures.

Which features apply to quota violations modeled with the optimizer?

• A.Quotas can be modeled for sourcing location, production, and consensus demand.
• B.Because quota violations shouldn't be possible, the non-delivery cost rate is less than quota violation cost.
• C.Min and Max Quotas have to be the same as sourcing ratios.
• D.The optimizer will only violate quotas if quotas are maintained as time-dependent key figures.