299-01 試験問題を無料オンラインアクセス

Within Cascade Pilot, Sequence Diagrams allow you to display information between two end points. You have a choice of displaying information for two different layers in the network stack. Descriptions of the sequence diagrams for the two Layers follow: (Select 2)

• A.Layer 4 Transport information. For example, for TCP this includes TCP flags, size in bytes, and sequence number between IP Addresses.
• B.Layer 2 information. For example, for Ethernet with 802.1Q encapsulation this includes the VLAN identifier and frame size between MAC Addresses
• C.Application header information. For example, for Web traffic this includes HTTP methods and message numbers (e.g. "200", "404").
• D.Layer 1 information. For example, for Ethernet tap points this includes signal levels and attenuation.
• E.Layer 3 information. For example, for IPv4 this includes the protocol, time-to-live (TTL), and IP Identifier between IP Addresses

Which of the following are true about Trend/Index data on a Cascade Shark appliancE. (Select 3)

• A.It is enabled by default per capture job.
• B.It is configured using the sa-wizard as part of the initial configuration.
• C.Includes the number of bytes and packets for each conversation seen by the Cascade Shark appliance.
• D.It is configured on a per-port basis.
• E.Allows Cascade Pilot to load views that take advantage of the Index more quickly.

What is the maximum number of custom applications (Layer 4 and 7 combined) permitted to be defined on a single Cascade Profiler?

• A.Unlimited
• B.125
• C.75
• D.100
• E.50

How many Cascade Notification Policy Levels are there?

• A.4
• B.3
• C.5
• D.1
• E.2

Which version of SNMP is supported for Switch Port Discovery on Cascade Profiler?

• A.SNMPv1 Only
• B.SNMPv1 and SNMPv2
• C.SNMPv2 Only
• D.SNMPv1 and SNMPv3