RCWA 試験問題を無料オンラインアクセス

A wireless administrator wishes to consolidate the management of RUCKUS APs by onboarding three new sites to SmartZone 5.2. The APs currently managed by this SmartZone cluster are running AP firmware 5.2.1.0.1038. The administrator has noted the following AP software versions for each of the sites:
The APs in San Mateo are running 200.7.10.202.121
The APs in Toronto are running 102.0.0.0.5
The APs in Mexico City are running 5.2.0.0.1412
Which three statements are true with regard to onboarding, one for each of these three sites? (Choose three.)

• A.Toronto devices will use LWAPP to communicate to SmartZone.
• B.Mexico City devices can use CLI commands to onboard.
• C.San Mateo devices can use ap-mode commands to onboard.
• D.San Mateo devices need to be running Solo Code.
• E.Toronto devices will use SSH to communicate to SmartZone.
• F.Mexico City devices are currently being managed by this cluster.

Review the output. Which two states can be determined from this output? (Choose two.) rkscli: get scg
----- SCG Information ------
SCG Service is enabled.
AP is managed by SCG.
State: RUN_STATE
Server List: 10.1.1.245,47.187.140.218
SSH tunnel connected to 10.1.1.245
Failover List: Not Found
Failover Max Retry: 2
DHCP Opt43 Code: 6
Server List from DHCP (Opt43/Opt52): Not found
SCG default URL: RuckusController
SCG config heartbeat intervals: 30 | 30
SCG gwloss|serverloss timeouts: 1800 | 86400
Controller Cert Validation: disable
OK

• A.AP data traffic is tunneled.
• B.Controller IP was set by DNS.
• C.Controller is behind a control NAT IP.
• D.AP is waiting join state approval.
• E.AP is accepted and managed by the controller.

Which capability within Client Isolation will allow clients to access specific destinations within the same subnet?

• A.Access control list
• B.Gateway access list
• C.Isolation whitelist
• D.Directed multicast

The Background Scanning interval is increased to 90 seconds. Which three processes will take longer to update their data? (Choose three.)

• A.Spectrum analysis
• B.Auto power adjustment
• C.Rogue AP detection
• D.Auto-channel selection
• E.Channel throughput measurement
• F.Connected client count

An admin has created a RUCKUS GRE tunnel profile in SmartZone.
Why is the new tunnel unavailable in the GRE Tunnel Profile dropdown when configuring the WLAN?

• A.GRE tunnel has not been associated with an AP Zone.
• B.The maximum GRE tunnel count has been reached.
• C.WLAN does not support GRE tunnels.
• D.A split tunnel profile has not been created.