1z1-822 試験問題を無料オンラインアクセス

You must configure your server to use IPMP with probe based failure detection enabled. Which statement is a valid constraint or feature that applies to this requirement?

• A.You must first disable link based detection before configuring probe-based failure detection.
• B.Link-based detection is supported only on Generic Lan Driver version 2 (GLDv2)complaint NICs.
• C.GLDv3 NICs configured for link based detection by default.
• D.GLDv2 NICs are not supported in Oracle Solaris 11.

You are creating a new SMF service named newservice. You perform the following steps:
- Create the XML manifest file to define the service.
- Create a script to be used to start and stop the service and set the execute permissions on this script.
What is the next step that you must perform to install this service?

• A.Export the service
• B.Create a snapshot of the service to be stored in the repository.
• C.Import the service.
• D.Enable the service

What does the following command change?
pkg set-publisher -G '*' -g http://server1.domain.com solaris

• A.It adds the server1.domain.com repository as an origin for the solaris publisher.
• B.It updates all Solaris publishers and deletes the server1.domain.com origin.
• C.It deletes all Solaris publishers and adds the server1.domain.com origin.
• D.It sets the origin for the Solaris publisher to server1.domain.com.
• E.It adds server1.domain.com to the Solaris publisher list.

You are tasked to reconfigure zone1 to use virtual interface vnic1 as its network interface. Which two steps must be included?

• A.Change the shared IP zone to an exclusive IP zone.
• B.From the global zone, set the IP address of vnic1 and configure the default route.
• C.Disable IP Filter and IPsec.
• D.Configure the NWAM NCP to Automatic.
• E.Reboot zone1 so that changes made with zonecfg take effect.

You are creating a native Oracle Solaris zone that will be called zd1. The zone must have a virtual network interface configured. You use the following command to create the zone configuration:
# zonecfg -z zd1
zonecfg:zd1> create
What is the minimum specification required to complete the configuration before the exit command is issued?

• A.A zonepath must be set.
• B.Both an anet configuration and a zonepath must be set.
• C.No other configuration parameters need to be set.
• D.An anet resource must be added.