1z1-489 試験問題を無料オンラインアクセス

Which statement is true regarding the SPARC M5-32 server SP (service processor) and SPP (service processor proxies)? Each SPARC M5-32 server has_____

• A.2x SP, and works with 4x SPP local in 4x IOU
• B.2x SP, and works with 4x SPP local in 4x DCU
• C.2x SP, and works with 16x SPP local in 4x DCU and 4x IOU
• D.2x SP, and works with 16x SPP local in 16x CMU

You are ready to run SunVTS. Which two commands can you use?

• A.startsunvts -all
• B.startvts
• C.startsunvts -g
• D.startsunvts-t

If you have a PDomain with expandable= false, which components will not be tested when the PDom goes through POST?

• A.CMIs
• B.DIMMs
• C.SSBs
• D.IOUs

Which three statements are correct about installing DIMMS?

• A.Be sure that you are properly grounded before inserting the DIMM(s) in the socket(s).
• B.If a DIMM slot LED is lit, press the Fault Remind button to turn off the LED.
• C.If a DIMM slot LED is lit, the fault is cleared only by the reset command In JLOM.
• D.When you press the DIMM Fault Remind button, the slot for a faulty DIMM is lit.
• E.When replacing a faulty CMU, you do not need to keep DIMMs in the same locations on thereplacement CMU, because the server has an intelligent load-balance feature.

You are performing some of the initial Service Processor (SP) login steps. How do you verify that you are on the Active SP?

• A.Enter > show /sp/redundancy status where the result is "status = Active",
• B.Enter > show /SP/redundancy status where the result is "status = Ready".
• C.Enter > show /sp/redundancy status where the result is "status = Go",
• D.Enter > show /SP/redundancy status where the result is "status = In progress".