1z1-429 試験問題を無料オンラインアクセス

Data Protection Manager gives you the capability to schedule backups of the application data on a regular basis. What are scheduled backups called in Data Protection Manager?

• A.application-aware backup
• B.consistency groups
• C.point-in-time backups
• D.checkpoints

The storage administrator is looking for events with a specific severity. Which three event severities can be filtered for easy searching?

• A.Normal
• B.Critical
• C.Error
• D.Warning
• E.Informational

Identify three available roles for a new user account created by the Primary Administrator.

• A.Administrator1
• B.FS1 Support
• C.Guest
• D.Administrator2
• E.Monitor

What is the minimum bending radius of fiber optic cable?

• A.2 inches (5.1 cm)
• B.3 inches (7.6 cm)
• C.5 inches (12.7 cm)
• D.4 inches (10.2 cm)
• E.6 inches (15.2 cm)

Which set of steps is the recommended cabling sequence with FS1-2 hardware components?

• A.1. Pilot 1: Install CMA, plug all cables, and route them Power first, Ethernet Last.
  2.Pilot 2: Same as above.
  3.Controller 1: Install CMA, plug and route cables Power first, Ethernet, SAS Controller
  Interconnects, SAS Controller to Strings and Front End Network Connections respectively.
  4.Controller 2: Same as above.
  5.DEs per string sequence.
• B.1. Controller 1: Install CMA, plug and route cablesPower first, Ethernet, SAS Controller
  Interconnects, SAS Controller to Strings, and Front End Network Connections respectively.
  2.Controller 2: Same as above.
  3.Pilot 1: Install CMA, plug all cables, and route them Power first, Ethernet last.
  4.Pilot 2: Same as above.
  5. DEs per string sequence.
• C.1. Controller 1: Install CMA, plug and route cables Power first, Ethernet,SASController
  Interconnects, SAS Controller to Strings and Front End Network Connections respectively.
  2.Controller 2: Same as above.
  3.DEs per string sequence.
  4.Pilot 1: Install CMA, plug al cablesand route them Power first, Ethernet Last.
  5.Pilot 2: Same as above.
• D.1. Pilot 1: Install CMA, plug all cables,and route them Power first, Ethernet last.
  2.Pilot 2: Same as above.
  3.DEs per string sequence.
  4.Controller 1: Install CMA, plug and route cables Power first, Ethernet, SAS Controller
  Interconnects, SAS Controller to Strings, and Front End Network Connections respectively.
  5.Controller 2: Same as above.