1z0-996-22 試験問題を無料オンラインアクセス

When the source of a Financial Transaction is canceled, what does it result in?

• A.No change occurs.
• B.The source Financial Transaction status is changed to "Canceled".
• C.A new reversal Financial Transaction is created.
• D.The source Financial Transaction is deleted and a new reversal Financial Transaction is created.
• E.The source Financial Transaction is deleted.

When a service agreement is created, it is based on a template called the Service Agreement Type (SA Type) and values may be defaulted from a Start Option.
Which three attributes can get defaulted from a Start Option? (Choose three.)

• A.Contract Quantities
• B.Rate
• C.Terms and Conditions
• D.Service to be billed
• E.CIS Division

What Service Order activity types does theapplication include?

• A.Enable Service; Disable Service; Cut for Non-Payment; Reconnect Service for Payment; Exchange Meter; Back-to-Back Service
• B.Start Service; Stop Service; Cut for Non-Payment; Reconnect Service for Payment; Exchange Meter; Move-In/Move-Out Service
• C.Start Service; Stop Service; Install Meter; Remove Meter; Exchange Meter; Move-In/Move-Out Service
• D.Enable Service; Disable Service; Install Meter; Remove Meter; Exchange Meter; Back-to-Back Service

Critical validation rules verify the integrity of the initial measurementdata (IMD). If an implementation needs to add new critical validations, where would you configure them?

• A.in the pre-processing algorithm of the IMD Seeder BO (Dl-IMDSeeder)
• B.as optionson the IMD Seeder BO (D1-IMDSeeder)
• C.in the schema of the IMD Seeder BO (D1-IMDSeeder)
• D.in the validation algorithm on the IMD Seeder BO (D1-IMDSeeder)
• E.as new lifecycle algorithms on the IMD Seeder BO (D1-IMDSeeder)

As part of the service order processing, the algorithm D1-CNSPINSDV (Connect SP and/or Install Device) determines if a specificactivity needs to be created based on the state of the service point.
Based on the status of the service point, what can this algorithm create?

• A.Device
• B.Service Point
• C.Smart Meter Command
• D.Device Configuration