1z0-481 試験問題を無料オンラインアクセス

How does Replicat know the structure of the source tables when the target has a different layout?

• A.Source Definitions file contains table layouts
• B.Discard file contains table layouts
• C.Parameter file contains table layouts
• D.Replicat uses an ODBC connection to connect to the source system tables
• E.GoldenGate trail file contains the metadata of incoming data

Which Manager Parameter sets will report current lag every hour and write a critical message for any Extract/Replicate with a lag over 60 minutes?

• A.LAGREPOBTHOURS 1, LAGINFOMINUTES 30, LAGCR JTTCAI-M I
• B.LAGBEPOBTHOURS 1, LAGINFO 1 and LAGCRITICAL 60
• C.LAGREPOBT 1, I.AGCRITICALHOURS 1
• D.LAGREPORTMINUTES 60, LAGINFOHOURS 1

You are responsible for replication between your central office and twelve regional nodes. What is the best product for you to use to actively monitor thirteen GoldenGate TDM instances and configure email alerts based on process status?

• A.Oracle GoldenGate veridata
• B.Oracle GoldenGate Director
• C.Oracle GoldenGate Monitor
• D.Oracle GoldenGate Transactional Data Management

Nicole is preparing initial data load Extract task EINI_HR using the parameter DBOPTIONS FECHBATCHSIZE 2000. What is likely to happen if one of her source tables includes LOB data?

• A.The Extract will perform poorly due to paging unless LOBMEMORY is increased.
• B.The Extract will revert to single-row fetch mode, and then resume array fetches afterwards.
• C.The Extract will abend unless LOBMEMORY is increased.
• D.The Extract will revert to single-row fetch mode for all tables.

Where can you find a list of the parameters being used by a Replicat process?

• A.Discard file
• B.Event log
• C.Process report
• D.System logs