1z0-404 試験問題を無料オンラインアクセス

From which Session Border Controller node in a high availability (HA) pair, could a network administrator trigger a system switchover manually by issuing the notify berpd force command?

• A.Active only
• B.Secondary only
• C.Standby orActive
• D.Active node that no longer has a heartbeat
• E.Standby only

What is the first thing you must do when setting up the boot parameters of the Session Border Controller?

• A.verify the configuration by executing the verify-config command
• B.reset thesystem clock
• C.disable FTP access to the wancom0 management interface
• D.know the superuser mode password and access the configuration mode
• E.obtain the bootparam license

Which two statements are correct about configuring realms and their corresponding interfaces? (Choose two.)

• A.You can configure more than one SIP interface per realm.
• B.Although you can use both TCP and UDP concurrently as the transport protocol, you can only have one SIP interface per realm.
• C.You can associate multiple home realms with a single network interface.
• D.You can associate multiple network interfaces with a single realm only when either TCP or UDP is used as the transport protocol.
• E.You can associate multiple realms with a single networkinterface.

What do you need to do to support ftp service on a media interface?

• A.Set the ftp-address parameter to enabled.
• B.Add the IP address of the interface in the hip-ip-list and telnet-address parameters.
• C.Add the IP address of the interface in the hip-ip-list and ftp-address parameters.
• D.Add the IP address of the remote device to the hip-ip-list and ftp-address parameters.
• E.Set the hip-address parameter to enabled.

You are configuring the boot parameters in the Session Border Controller.
Which three statements are true about the boot parameters? (Choose three.)

• A.The target name is usedfor domain name resolution.
• B.The boot parameters are stored in Non-Volatile Random Access Memory (NVRAM).
• C.A reboot is always required to apply any change to the boot parameters.
• D.The system clock is a boot parameter.
• E.The boot parameters are not affected by the activate-config command.