1z0-1091-22 試験問題を無料オンラインアクセス

Which THREE features should you set up in the Cloud Service Payload Processing configuration?

• A.Head-end systems (HES)
• B.Key rings and key pairs
• C.File system directory SFTP setup
• D.Object Storage locations

Momentary outages are very short-term outages where an outage event is sent and a restoration event is received in less than a few minutes.
Which TWO system components would you configure to ignore momentary outages?

• A.Reporting categories
• B.Device events
• C.AMI commands
• D.Activities

Which statement is true about usage transaction?

• A.It is created by an external source or MDM, which uses the usage calculation engine to generate a final value. Valuation, Estimation, and Editing (VEE) can be configured but when called in real time, usage transaction may not be saved.
• B.It is created by an external source or Meter Data Management (MDM), which uses the usage calculation engine to generate usage values.
• C.It is created by an external source or MDM, which uses the usage calculation engine to generate a final value. VEE can be configured and usage transaction is saved.
• D.It must be created by an external system and it must be stored in the database.

Which TWO Validation, Estimation, and Editing (VEE) rules are typically configured on a project for consumption synchronization processes?

• A.Sum check: Ensure the two measuring components are in sync.
• B.Interval adjustment from scalar: Adjust the interval curve to the register consumption.
• C.Unit of Measure (UOM) check: Ensure UOMs are correct.
• D.Low check: Check for invalid low usage.

How do you configure the derived values that are relevant for a device?

• A.Configure the derived values on the measuring component type for the measuring components to be defined on the device.
• B.Configure the derived values on the device type for the derived values to be defined on the device.
• C.Configure the derived values on the measuring component for the measuring components to be defined on the device.
• D.Configure the derived values an the final measurement type for the measuring components to be defined on the device.