NCS_20022101010 試験問題を無料オンラインアクセス

The method of Flexi Multiradio BTS antenna line supervision is done by:

• A.Random usage of TRX Loop tests when timeslot is in idle mode.
• B.Monitor the MCPA temperature at BCCH TRX.
• C.Random usage of IDD Loop tests when timeslot is in idle mode.
• D.Via voltage standing wave ratio (VSWR) monitoring.

Which Network operation mode is in use, if only GSM control channels are used for GPRS operation?

• A.NOM II.
• B.NOM IV.
• C.NOM III.
• D.NOM I.

The Nokia Flexi Multiradio 10 Base Station supports:

• A.Flexi Multiradio 10 Base Station does not support the old legacy network interfaces. It is a true Ethernet-based transport with security BTS solution, synchronization and timing methods based on synchronous Ethernet, timing over packet, and GPS methods.
• B.Supports 3GPP functions and features in 3GPP release 9 and beyond with modules open to Base Station Architecture Initiative (OBSAI) and Common Public Radio Interface (CPRI).
• C.GSM/EDGE, CDMA2000, WCDMA, HSPA and HSPA evolution, LTE TDD/FDD.
• D.GSM/EDGE, WCDMA, HSPA and HSPA evolution, LTE TDD/FDD, NMP450.

A new project has been handed over to you and you want to review its pilot reports. Where can you look for them?

• A.ShareInside.
• B.BOXI.
• C.Resolve.
• D.Sharenet.

Which of the following statement is true for 20W GSM Power License usage with Flexi Multiradio BTS Edge.

• A.No 20W GSM Power License is required for a configuration up to 40W per PA in RFM Module.
• B.No License is requied for 20W GSM Power License.
• C.License is requied even up to 20W per PA.
• D.No 20W GSM Power License is required for a configuration up to 20 W per PA in RFM Module.