NS0-593 試験問題を無料オンラインアクセス

A customer enabled NFSv4.0 on an SVM and changed the client mount from NFSv3 to NFSv4. Afterwards, the customer found that the directory owner was changed from root to nobody.
In this scenario, which statement is true?

• A.The export policy is not configured properly.
• B.The clients must be restarted to start using NFSv4.
• C.The customer did not configure name services on the SVM.
• D.The ID mapping domains do not match between the client and server.

Refer to the exhibit.

Referring to the exhibit, from which delay center is most of the latency for voll?

• A.Data
• B.Disk
• C.NVRAM
• D.Network

You have a NetApp ONTAP cluster consisting of four NetApp FAS8200 controllers with two NetApp CN1610 cluster switches running ONIAP 9.8 software. You are receiving several alert messages stating that the cluster network has degraded. After troubleshooting, you determine that the errors are being generated from Node 2, interface e0b.
In this scenario, what should you do first to solve this problem?

• A.Replace the motherboard on Node 2.
• B.Replace the Twinax cable between Node 2, Interface e0b. and the NetApp CN1610 switch.
• C.Replace both NetApp CN1610 switches.
• D.Replace the NetApp CN1610 switch that connects to Node 2, interface e0b.

Your customer has deployed a two petabyte NetApp ONTAP FlexGroup volume across their 4-node ONIAP 9.8 cluster. They plan to store over three billion files. They want to prevent file 10 conflicts since files are placed into the FlexGroup volume.
In this scenario, which two NFS SVM parameters should be enabled? (Choose two.)

• A.-v4-fsid-change
• B.-v3-64bit-identifiers
• C.-v4-64bit-idantifiers
• D.-v3-fsid-change

A customer wants to connect a NetApp AFF A700 system to a 40GbE switch. The controllers have a 10/40G Ethernet card in slot 4 for this purpose. The link comes up fine on node 2, but it will not come up on node 1. You look at the AutoSupport data for the nodes in question and see the output shown in the exhibit.

What is the cause of the customer's problem?

• A.The cable is plugged in upside down.
• B.The ports are configured for 4x10Gbit instead of 40Gbit.
• C.The port has an incorrect SFP inserted.
• D.The incorrect cable is used.