NS0-507 試験問題を無料オンラインアクセス

What is the correct provisioning order of a new ONTAP storage solution?

• A.Volumes, aggregates, LUNs
• B.Aggregates, volumes, LUNs
• C.LUNs, volumes, aggregates
• D.LUNs, aggregates, volumes

You configured a new host and followed all the recommended cabling, configuration, and the best practice guides, However, the host OS is reporting one less path to storage than expected.
In this scenario, which two diagnostic commands would assist in insolating the path to investigate? (Choose two.)

• A.fcp status
• B.fcp portname show
• C.fcp ping-igroup
• D.fcp ping-initiator

You have a host with multiple initiator ports attaching to a single SAN LIF.
With this setup, which action is required?

• A.You must use an individual SAN LIF for each initiator port.
• B.You must use a SAN LIF failover group.
• C.You must use host multipathing software.
• D.You must use a portset.

You are asked to configure the Service Processor on a newly installed node, and must verify the following command:
system-service processor network modify -node local -address-family IPv4 -enable true - ip-address 192.168.123.98 -netmask 255.255.255.0
Which statement about this command is true?

• A.The gateway IP address is missing.
• B.The Link Local IP Address is missing.
• C.-nodeshould reference the actual node name.
• D.IPv6 is required for the SP.

You are configuring a Fibre Channel SAN in your cluster for the first time.
In this scenario, which switch feature is required for ONTAP Fibre Channel SAN to operate correctly?

• A.N_Port ID Virtualization (NPIV)
• B.Dynamic Path Selection (DPS)
• C.iSCSI Type, Length, Value (TLV)
• D.Forward Error Correction (FEC)