NS0-502 試験問題を無料オンラインアクセス

Which command do you use to see the rate of change between two successive Snapshot copies in a flexible volume in Data ONTAP?

• A.snap diff
• B.snap calculate
• C.snap delta
• D.snap space

You have a Windows 2003 host using the NetApp ONTAP DSM MPIO environment with a FAS6000 high availability configuration running single image cfmode.
When you disconnect a cable from the FC switch to a storage target port, how will the I/O fail over?

• A.I/O will fail over to any port on either controller that is part of the associated portset. Choice of path will be controlled by NetApp storage system igroup settings.
• B.I/O will fail over to any port on the original controller but NOT on the partner controller that is part of the associated portset. Choice of path will be controlled by the host's MPIO weighting table.
• C.I/O will fail over to any port on the original controller that is part of the associated portset. Choice of path will be controlled by NetApp storage system igroup settings.
• D.I/O will fail over to any port on either controller that is part of the associated portset. Choice of path will be controlled by the host's MPIO weighting table.

You are about to replace a failed Brocade Fibre Channel switch. Which three steps do you take prior to connecting the switch in the SAN? (Choose three.)

• A.Preload the zoning information from the fabric onto the new switch.
• B.Change the domain ID of the replacement switch to the domain ID of the failed switch.
• C.Clear all zoning configurations on the replacement switch.
• D.Force the new switch to be the principle switch.
• E.Change the core PID format of the replacement switch to the core PID format of the failed switch.

Which command collects detailed diagnostic information from a Brocade FC switch?

• A.diagshow
• B.showdiag
• C.showsupport
• D.supportshow

Which option needs to be set on a volume to guarantee that it cannot be affected by other volumes?

• A.None
• B.Space Reserved
• C.Volume
• D.Reservation Enabled