NS0-184 試験問題を無料オンラインアクセス

You installed a new 4-node AFF A400 ONTAP 9.8 cluster. The AFF400 controller data ports were automatically discovered by "automatic port placement".
In this scenario, which two ONTAP network settings were automatically configured? (Choose two.)

• A.broadcast domains
• B.IPspaces
• C.routes
• D.subnets

You completed a 2-node AFF A700 installation according to the poster. You run the disk show -fields owner command and notice that all drives are assigned to node 1.
In this scenario, which tool would you use to access documentation and guidelines to solve the issue?

• A.NetAppDocs
• B.Active IQ One Collect
• C.NET2
• D.Active IQ Unified Manager

You are installing a new six-node ONTAP 9.8 cluster. You have completed the initial configuration of the cluster interconnect switches and the ONTAP cluster.
In this scenario, which feature should you enable?

• A.cluster switch logging
• B.IPv6 on all cluster ports
• C.data center bridging protocol
• D.cluster switch health monitor

You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring interface groups for higher performance and resiliency.
Which two NetApp best practices should you follow to satisfy these performance and resiliency requirements? (Choose two.)

• A.Use ports from different NICs.
• B.Use ports with the same chipsets.
• C.Use ports from the same NICs.
• D.Use ports with different chipsets.

You have a 2-node FAS8300 switchless ONTAP 9.8 cluster that serves NAS volumes. You have a data SVM that connects to the network using multimode LACP with VLAN tags.
In this scenario, which front-end FAS8300 network port would you create the data LIFs?

• A.e0e
• B.a0a-100
• C.e0e-100
• D.a0a