NS0-182 試験問題を無料オンラインアクセス

Which tool allows you to create a new FlexGroup volume?

• A.OnCommand Unified Manager
• B.Cluster Config Builder
• C.NetAppDocs
• D.OnCommand System Manager

You are asked to installed a new cluster with six FAS8060 nodes. While running Config Advisor, you determine that there is a newer firmware version for 16 HDDs.
How should this situation be handled?

• A.Unless the customer advises otherwise, leave the firmware alone and document the version of ONTAP being used to explain the issue.
• B.Unless the customer advises otherwise, upgrade the firmware on the HDDs to correct the Config Advisor error.
• C.Prior to leaving the site, confirm the version of ONTAP that the customer wanted installed to correct the Config Advisor error.
• D.Prior to leaving the site, advise the customer that firmware is included with the version of ONTAP they selected.

Upon finishing the installation of a new system for a customer, they request that you train them on how to administer the system.
In this scenario, which two responses are appropriate? (Choose two.)

• A.The
  answers to any of your questions can be found on the NetApp SmartSolve site (http://smartsolve.netapp.com).
• B.If you have a specific issue, you can visit the Knowledge Base Web site (https://kb.netapp.com).
• C.You should open a case with NetApp Support for all future questions with low priority and include the keyword "Training" in the title.
• D.Visit the NetApp MySupport Site and look for the Express Guides, they will guide you through the daily tasks and provide input and output examples.

You are installing a new 2-node AFF A220 cluster running ONTAP 9.5. The customer would like to use the UTA2 adapters from the first controller to connect to the 10GbE front-end switches. On the second controller, they would like to use the first UTA2 port as a target FC port, and the second as an FC initiator.
In this scenario, according to NetApp Best practices, what should your customer do?

• A.Change the first two ports of each controller to FC and the last two to CNA.
• B.Change all the UTA2 ports from CNA mode to FC mode.
• C.Change all the UTA2 ports to CNA to support both FC and Ethernet.
• D.Change the UTA2 ports from CNA mode to FC mode on the first controller.

A customer has recently purchase a new ONTAP 9.0 storage system and wants you to join the nodes to an existing cluster running ONTAP 9.5.
What is the first step for adding the new controllers to the existing cluster?

• A.You must match the operating system.
• B.You must ensure that all network switches are upgraded and online.
• C.You must configure the existing cluster to accept the Joining nodes.
• D.You must make sure that there Is the same amount of disk shelves attached to all nodes.