NS0-176 試験問題を無料オンラインアクセス

How should the speed be configured on the Nexus 5548 port connecting to the Nexus 1100-X?

• A.Speed 1000000
• B.Speed 1G
• C.It should not be configured - the 5548 will auto detect the correct speed
• D.Speed 1000
• E.Speed 10

You run NetApp ConfigAdvisor against you FAS8060A storage system. The report states that the flow control settings for ports e0a on each node are incorrect.
Which set of commands will correct this problem?

• A.network interface modify- node netapp-01 -port e0a -flowcontrol -admin none network interface modify -node netapp-02 -port e0a -flowcontrol - admin none
• B.network interface modify- node netapp-01 port e0a-flowcontrol-admin full network interface modify- node netapp-02 port e0a-flowcontrol-admin full
• C.network port modify- node netapp-01 port e0a-flowcontrol-admin full network port modify- node netapp-02 port e0a-flowcontrol-admin full
• D.network port modify -node netapp-01 -port e0a -flowcontrol-admin none network port modify -node netapp-02 -port e0a -flowcontrol-admin none

How many ACTIVE SPAN sessions exist on a Fabric Interconnect?

• A.4
• B.2
• C.8
• D.1
• E.16

Exhibit:

You have FCoE configured between your Nexus 5672UP switches and UCS Fabric Interconnects running in FC end-host mode. You are experiencing disk I/O errors on your VMware FCoE datastore, but the NFS data stores on the same NetApp storage system are not exp eriencing any problems.
Referring to the Nexus output shown in the exhibit, what would cause this problem?

• A.The no-drop QoS classes on the Fabric Interconnects are different than those on the Nexus switches.
• B.Port flow-control is currently off.
• C."VL bmap" is hard to set to "off".
• D.The FCoE uplinks from the Fabric Interconnects must use the ports on the far right side of the Nexus switches.

Exhibit:

You are configuring iSCSI boot from SAN on your UCS blades.
Referring to the exhibit, how many paths will there be to the Boot LUN?

• A.6
• B.4
• C.2
• D.8