NS0-171 試験問題を無料オンラインアクセス

You are an administrator of a UCS system. You notice that when you apply a setting that requires a reboot, the affected hardware reboots immediately without warning. You would like to reboot to be acknowledged by an administrator instead.
What should you do to accomplish this task.

• A.Create aa BIOS policy.
• B.Create a scrub policy.
• C.Create a maintenance policy.
• D.Create updating templates.

You are attempting to establish a cluster peer relationship between two NetApp clusters, but the peering process fails.
What is a cause for this failure?

• A.The intercluster LIF on each node cannot communicate with the intercluster LIF on each node in the peer cluster.
• B.The cluster LIFs on each node cannot communicate with the cluster LIFs on each node in the peer cluster.
• C.The cluster management LIF for the cluster cannot communicate with the cluster management LIF for the peer cluster.
• D.The node management LIF on each node cannot communicate with the node management LIF on each node in the peer cluster.

Which set of commands maps VLAN 100 to VSAN 100?

• A.Nexus 5000-A#configure terminalNexus 5000-B (config) # vsan databaseNexus 5000-A (config)# vsan 100Nexus 5000-A (config-vsan) # fcoe vsan 100
• B.Nexus 5000-B# configure terminalNexus 5000-B (config) # vsan databaseNexus 5000-B (config-vsan)# vsan 100Nexus 5000-B(config- vsan) #vsan 100 name FCoE-VLAN 100
• C.Nexus 5000-B# configure terminalNexus 5000-B(config-vsan) # vlan 100Nexus 5000-B (config-vsan)# vsan 100 name vsan100
• D.Nexus 5000-A#configure terminalNexus 5000-A (config) # vlan 100Nexus 5000-A (config-vlan_ #fcoe vsan 100

You want to verify that you have configured Multipath HA correctly for all of the attached disk shelves on a NetApp cluster.
Which two commands would you execute from the cluster CLI prompt to accomplish this task? (Choose two.)

• A.sysconfig -a
• B.node run -node * -command disk show
• C.node run -node * sysconfig -a
• D.node run -node * storage show disk -p

Click the exhibit button.

An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The
UCS blade servers are configured for SAN boot, and all zoning and LUN mapping for a single 50 GB LUN have been configured. When selecting the install disk during the
Windows installation, the symptoms and error shown in the exhibit are displayed.
What should the administrator do to solve the problem?

• A.Install the Cisco VIC storage miniport driver for Windows 2012 R2.
• B.Change the LUN OS type to "Windows 2008 or later".
• C.Configure a single path to the LUN for the duration of the Windows installation process.
• D.Delete the extra LUNs that were created.