NS0-163 試験問題を無料オンラインアクセス

How would you initiate a cluster takeover of filer2 from filer 1?

• A.filer2> cf giveback
• B.filerl> cf giveback
• C.filer 1> cf takeover
• D.filer2> cf takeover

The required hardware to add SyncMirror to an existing Clustered Failover system consists of:

• A.Disk shelves, adapters and cabling
• B.Disk shelves and cabling
• C.Disk shelves and cluster interconnect
• D.Disk shelves and termination switches

Which one of the following statements does not apply to the SnapMirror visibility-interval variable?

• A.The default interval value is 5 minutes
• B.By setting a value, you specify the amount of time before an automatic snapshot is created on the source volume that is synchronously mirrored
• C.This variable controls the view of the data on the destination system
• D.The smallest interval value supported is 30 seconds

Which workload type supports Autonomous Ransomware Protection?

• A.VMFS
• B.SAN
• C.NAS
• D.Object

Which two steps should an administrator take to create a two-node ONTAP Select cluster that spans two data centers and provide automated switchover without any data loss? (Choose two.)

• A.Set up a SnapMirror Synchronous relationship in StrictSync mode to prevent any data loss in case of a failover
• B.Use ONTAP Select Deploy to install the nodes on the VMware environment
• C.Make sure that the ONTAP Select Deploy VM resides at a third location other than the two data centers
• D.Use ONTAP Mediator service to make sure that a quorum exists for the two nodes