NS0-158 試験問題を無料オンラインアクセス

Click the exhibit button.

Referring to the exhibit, you have a FlexGroup volume that is 250 TB with 10 constituents.
You apply the volume modify -vserver fg1_vs -volume fg1 -size 350TB command.
What affect does the command have on the FlexGroup volume and its constituents?

• A.It grows the FlexGroup volume to 350 TB by increasing the size of each constituent to 35 TB.
• B.It grows the FlexGroup volume to 600 TB by adding 14 new constituents.
• C.It grows the FlexGroup volume to 350 TB by adding four new constituents
• D.It grows the FlexGroup volume to 600 TB by increasing the size of each constituent to 60 TB.

Click the exhibit button.

Referring to the exhibit, which statement about the volume move process is true?

• A.Client access is being redirected to the destination location during this phase of the operation.
• B.The initial replication phase sent 39 MB from the source to the destination location.
• C.The cutover process failed and is in a holding pattern before being attempted again.
• D.Client access to the volume is blocked during this phase of operation.

You have a 2-node NetApp cluster. You would like to use an onboard UTA2 port for host connectivity. The port was previously connected to a tape library using native FC.
What must you do to configure the port for host connectivity?

• A.Change the port mode to CNA.
• B.Change the FC type to target.
• C.Change the port mode to FC.
• D.Change the FC type to initiator.

Which type of connectivity is supported when connecting third-party arrays through FlexArray Virtualization for back-end storage to a NetApp cluster?

• A.iSCSI
• B.FC
• C.SAS
• D.Infiniband

A customer has configured SnapDrive for Windows to assist in creating Snapshot copies of a LUN.
In SnapDrive, the transport protocol configuration uses the vsadminuser account for authentication.
SnapDrive fails to connect to the SVM.
Why did this failure occur?

• A.The vsadmin account is locked or does not have a password.
• B.Transport protocol requires a domain Windows account.
• C.Transport protocol requires a local Windows account.
• D.SnapDrive requires a cluster-wide privileged account.