MSC-121 試験問題を無料オンラインアクセス

You are responsible for designing an 802.11n controller based wireless LAN for your organization using independent access point technology, The Information Technology team has decided the wireless LAN controllers should be installed on the core layer at the headquarters office location configured for centralized forwarding. Which statements are true concerns with respect to this type of installation (select TWO)?

• A.Network core layer deployments should always use 10 Gigabit (or faster) Ethernet components.
• B.S02.11n independent access points require the controller be installed at the network access layer only.
• C.The WLAN controller at the core layer may be a bottleneck and limit scalability if not properly planned.
• D.With centralized forwarding enabled all wireless traffic is tunneled to the WLAN controller that is connected to the network core layer.

You are working with a new customer in a harsh climate, who is interested in establishing an outdoor wireless link between two buildings. Which of the following options below would you recommend with regard to the APs and mode?

• A.Use two AP7161's set to Mesh Mode.
• B.Use two AP650's set to Mesh Mode.
• C.Use two AP6532S set to Mesh Mode.
• D.Use two AP7131's set to Mesh Mode.

You are designing a WLAN for a new customer and have been given a Customer Checklist
for WLAN.
Given this checklist, please answer the test item(s) below.

Listed below are potential modifications to the client requirements. Which of the following would change the make and model of the access points selected for this design (select TWO) ?

• A.Wall mounting is now an option
• B.VOIP application support is required
• C.Smart card support is required
• D.Site Survivability is required

The AP7131 Independent AP allows a network administrator to place a remote Access Point into which of the following modes to assist with frequency analysis and issue resolution from the Network Operation Center (NOC) or other centralized location?

• A.Protocol Analysis Mode
• B.Sniffer Mode
• C.Power Over Ethernet (PoE) Mode
• D.Spectrum Analysis Mode

Your customer has a requirement that all APs used in the design have dual radios, 2.4 GHz and 5.8 GHz. Which of the following APs cannot meet this requirement?

• A.AP6532
• B.AP650
• C.AP7131
• D.AP6511