70-741 試験問題を無料オンラインアクセス

You are deploying Software Defined Networking (SDN) by using Windows Server 2016.
You plan to deploy a three-node Network Controller cluster. You plan to use virtual machines for the network controller and the management client. The virtual machines will NOT be domain-joined.
You need to configure authentication for the cluster.
Which command should you run?

• A.Install-NetworkController -Node @{Node1, Node2, Node3} -ClientAuthentication Kerberos
• B.Install-NetworkController -Node @{Node1, Node2, Node3} -ClientAuthentication X509
• C.Install-NetworkControllerCluster -Node @{Node1, Node1, Node3} -ClientAuthentication X509
• D.Install-NetworkControllerCluster -Node @{Node1, Node1, Node3} -ClientAuthentication Kerberos
• E.Install-NetworkControllerCluster -Node @{Node1, Node1, Node3} -ClientAuthentication None

You have servers named Server1 and DHCP1. Both servers run Windows Server 2016. DHCP1 contains an IPv4 scope named Scope1.
You have 1,000 client computers.
You need to configure Server1 to lease IP addresses for Scope1. The solution must ensure that Server1 is used to respond to up to 30 percent of the DHCP client requests only.
You install the DHCP Server server role on Server1.
What should you do next?

• A.From the DHCP console, create a superscope.
• B.From Server Manager, install the Failover Clustering feature.
• C.From Server Manager, install the Network Load Balancing feature.
• D.From the DHCP console, run the Configure Failover wizard.

Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution. Determine whether the solution meets the stated goals.
Refer to exhibit:

Server1 has two virtual machines named VM1 and VM that run Windows Server 2016. VM1 connects to Private VM2 has two network adapters.
You need to ensure that VM1 connects to the corporate network by using NAT.
Solution: You connect VM2 to private1 and External1. You run the New-NetNatIpAddress and the New-NetNat cmdlets on VM2.You configure VM1 to use VM2 as the default gateway.
Does this meet the goal?

• A.No
• B.Yes

Your network contains an Active Directory domain. The domain contains two domain controllers named DO and DC2. DC! and DC2 host an Active Directory-integrated DNS zone named contoso.com You have two DNS Client Subnets named Subnet1 and Subnet2.
You plan to create two DNS records for www.contoso.com. One record will point to 10.1.23, and the other record will point to 172.23.6.5.
You need to ensure that www.contoso.com resolves to:
* 10.1.2.3 from Subnet1

• A.one DNS recursion policy, two DNS zone delegations, and the DNS records
• B.one DNS query resolution policy, two DNS zone delegations, and the DNS records
• C.one DNS query resolution policy, two DNS zone delegations, and the DNS records
• D.one DNS zone scope, two DNS query resolution policies, and the DNS records

You have multiple servers that run Windows Server 2016.
The DNS Server server role is installed on a server named Server1.
You need to configure Server1 to use a DNS forwarder that has an IP address of 192.168.10.15.
What should you run?

• A.netsh.exe
• B.Set-DhcpServerDatabase
• C.dns.exe
• D.Set-DhcpServerv4DnsSetting
• E.dism.exe
• F.Set-DNSServerSetting
• G.Set-DhcpServerv6DnsSetting
• H.dnscmd.exe