70-734 試験問題を無料オンラインアクセス

DRAG DROP
You have a Windows Assessment and Deployment Kit (Windows ADK) environment that contains a
fileserver named Server1. Server1 runs Windows Server 2012 R2.
You copy the Windows 10 installation media to a shared folder on Server1. You install Windows 10 on a
reference computer, and then you generalize the installation.
You need to replace the image in the share with an image of the reference computer.
Which three actions should you perform in sequence? (To answer, move the appropriate three actions
from the list of actions to the answer and arrange them in the correct order.)

正解：

DRAG DROP
You are preparing a GTP disk for a Unified Extensible Firmware Interface (EUFI)-based computer from
Windows Preinstallation Environment (Windows PE).
You need to identify which file system must be used for the EFI system partition, the MSR partition, and
the Windows partition.
What should you identify? (To answer, drag the appropriate actions to the correct partitions. Each action
may be used once, more than once, or not at all. You may need to drag the split bar between panes or
scroll to view content.)

正解：

A technician applies an image of Windows to a client computer.
The technician reports that several errors occurred during the Windows Welcome phase of the setup.
You need to view the errors that occurred during Windows Welcome.
Which file should you view?

• A.Cbs_unattend.log
• B.Setupapi.offiine .log
• C.Setupapi.dev.log
• D.Setupact.log

You have a Windows image that is configured to start to the Windows Welcome screen.
You need to ensure that the image starts in audit mode.
You mount the image.
What should you do next?

• A.Create an answer file named Audit.xml. Copy the answer file to the Windows\Panther\Unattend folder
  in the image.
• B.Create an answer file named Unattend.txt. Copy the answer file to the Windows folder in the image.
• C.Create an answer file named audit. txt. Copy the answer file to the Windows folder in the image.
• D.Create an answer file named Unattend.xml. Copy the answer file to the Windows\Panther\Unattend
  folder in the image.

You have a server named Server1 that runs Windows Server 2012 and has the Windows Deployment
Services server role installed.
You recently removed a third-party DHCP server from the network, and then installed the DHCP Server
role on Server1.
You create a scope on Server1.
You discover that client computers attempting to receive a Windows 10 image fail to connect to Server1.
You verify that the client computers on the network can receive an IP address from Server1.
You need to ensure that the computers attempting to receive an image can connect to Server1.
Which two actions should you perform? Each correct answer presents part of the solution.

• A.From the Windows Deployment Services console, click the PXE Response tab, and then set the value
  of the Delay in seconds to 3.
• B.From the Windows Deployment Services console, click the DHCP tab, and then select the Do not listen
  on port 67 check box.
• C.From the Windows Deployment Services console, click the DHCP tab, and then select the
  Configure DHCP option 60 to indicate that this is also a PXE server check box.
• D.From the DHCP console, click Server Options, and then set the value of Option 67 to install.wim.
• E.From the DHCP console, click Server Options, and then set the value of Option 66 to Server1.