70-412 試験問題を無料オンラインアクセス

You are employed as a network administrator at ABC.com.
ABC.com has an active directory domain named ABC.com.
All servers on the ABC.com network have Windows Server 2012 R2 installed.
ABC.com has a server named server1 which is configured as a DHCP server.
You have created a superscope on server1.
Which of the following describes the reason for creating a superscope?(choose all that apply.)

• A.To support DHCP clients on a single physical network segment where multiple logical ip networks are used.
• B.To support remote DHCP clients located on the far side of DHCP and BOOTP relay agents.
• C.To allow for the sending of network traffic to a group of endpoints destination hosts.
• D.To provide fault tolerance

Your network contains an Active Directory forest named contoso.com. All servers run Windows Server 2012 R2.
The domain contains four servers. The servers are configured as shown in the following table.

You need to deploy IP Address Management (IPAM) to manage DNS and DHCP.
On which server should you install IPAM?

• A.DC1
• B.DC3
• C.Server1
• D.DC2

Your network contains an Active Directory domain named contoso.com. The domain contains two member servers named Server1 and Server2.
You install the DHCP Server server role on Server1 and Server2. You install the IP Address Management (IPAM) Server feature on Server1.
You notice that you cannot discover Server1 or Server2 in IPAM.
You need to ensure that you can use IPAM to discover the DHCP infrastructure.
Which two actions should you perform? (Each correct answer presents part of the solution. Choose two.)

• A.On Server2, create an IPv4 scope.
• B.On Server1, run the Add-IpamServerInventory cmdlet.
• C.On Server2, run the Add-DhcpServerInDc cmdlet
• D.On both Server1 and Server2, run the Add-DhcpServerv4Policy cmdlet.
• E.On Server1, uninstall the DHCP Server server role.

Your network contains an Active Directory domain named adatum.com.
The domain contains four servers.
The servers are configured as shown in the following table.

You plan to deploy an enterprise certification authority (CA) on a server named Server5.
Server5 will be used to issue certificates to domain-joined computers and workgroup computers.
You need to identify which server you must use as the certificate revocation list (CRL) distribution point for Server5.
Which server should you identify?

• A.Server 2
• B.Server 3
• C.Server 1
• D.Server 4

You have a server named Server1 that runs Windows Server 2012 R2. The storage on Server1 is configured as shown in the following table.

You plan to implement Data Deduplication on Server1.
You need to identify on which drives you can enable Data Deduplication.
Which three drives should you identify? (Each correct answer presents part of the solution. Choose three.)

• A.E
• B.C
• C.G
• D.D
• E.F