JN0-690 試験問題を無料オンラインアクセス

Click the Exhibit button.
-- Exhibit -[edit] user@router# show interfaces
ge-1/1/2 {
vlan-tagging;
unit 100 {
vlan-id 100;
family inet {
address 192.168.0.1/30;
}
}
}
lo0 {
unit 0 {
family inet {
address 10.10.10.1/32;
}
}
}
[edit]
user@router# show protocols ospf
area 0.0.0.0 {
interface ge-1/1/2.0 {
interface-type p2p;
metric 250;
}
interface lo0.0;
}
[edit]
user@router# run show ospf interface Interface State Area DR ID BDR ID Nbrs lo0.0 DR 0.0.0.0 10.10.10.1 0.0.0.0 0
[edit] user@router# -- Exhibit -
Referring to the exhibit, why does only the loopback interface appear in the show ospf interface output?

• A.The incorrect logical unit for the ge-1/1/2 interface is configured under the OSPF hierarchy.
• B.The ge-1/1/2 interface is configured under the wrong OSPF area.
• C.The interface-type is not configured properly on the ge-1/1/2 interface.
• D.The metric configured on ge-1/1/2 is not valid.

Click the Exhibit button.
-- Exhibit -user@router> show system users
9:28PM up 2 days, 3:02, 2 users, load averages: 0.06, 0.13, 0.09 USER TTY FROM LOGIN@ IDLE WHAT lab u0 -9:13PM - -cli (cli) admin p0 10.210.15.30 9:45PM - -cli (cli) -- Exhibit -
Referring to the exhibit, which two statements are true? (Choose two.)

• A.The lab user's session will be cleared after issuing the command request system logout user lab.
• B.The admin user is connected through a console session.
• C.Both user sessions will be cleared after issuing the command request system logout terminal.
• D.The admin user is connected through a Telnet or SSH session.

You are asked to provide an audit trail for all user activity on your Junos device.
Which syslog configuration statement accomplishes this task?

• A.user * {
  any any;
  }
  file messages {
  any info;
  authorization info;
  }
• B.user * {
  any emergency;
  }
  file messages {
  any notice;
  authorization info;
  }
  file audit-commands {
  authorization any;
  }
• C.user * {
  any any;
  }
  file messages {
  any notice;
  authorization info;
  }
• D.user * {
  any emergency;
  }
  file messages {
  any notice;
  authorization info;
  }
  file interactive-commands {
  interactive-commands any;
  }

Which route would a packet destined to 192.168.14. take?

• A.192.168.14.0/24 *[BGP/100]
• B.192.168.14.0/24 *[BGP/70]
• C.192.168.14.0/24 *[BGP/200]
• D.192.168.64.0/21 *[Direct/0]

You suspect that your router is missing the .0/24 routes for your local network. You first want to look for the routes on the control plane before troubleshooting the data plane.
Which operational mode command should you issue?

• A.show route flow validation table
• B.show route
• C.show route forwarding-table
• D.show arp