JN0-682 試験問題を無料オンラインアクセス

Which two statements about ZTP are true? (Choose two.)

• A.The image storage service and the DHCP server can be running on different server hosts.
• B.When a switch is booted. DHCP requests are sent only through the management Ethernet interface.
• C.The image storage service must be running on the same server host where the DHCP service is running.
• D.When a switch is booted, DHCP requests are sent through the management interface as well as attached revenue ports.

Refer to the exhibit.

Which statement is correct about the highlighted code segment and VXLAN frame shown in the exhibit?

• A.This statement is optional and keeps the VLAN header in the Original L2 Frame, if included.
• B.This statement is required and keeps the VLAN header in the Original L2 Frame, if included.
• C.This statement is required and removes the VLAN header in the Original L2 Frame, if included.
• D.This statement is optional and removes the VLAN header in the Original L2 Frame, if included.

You are asked to design a deployment plan for a large number of QFX Series switches using ZTP. The ZTP deployment plan must ensure all switches are configured with their designated configuration file.
Which DHCP option and subscription combination would be used to accomplish this task?

• A.DHCP option 43 a suboption of 01.
• B.DHCP option 66 a suboption of 01.
• C.DHCP option 43 a suboption of 00.
• D.DHCP option 66 a suboption of 00.

Which statement is true about the route shown in the exhibit?

• A.The VNI for this route is 304.
• B.The route target on this route is 1000
• C.The route uses a type-1 route distinguisher.
• D.The route is an EVPN type-1 route.

You are attempting to configure filter-based forwarding in your data center. All traffic from Host1 that is going to Host2 should be inspected by the data center firewall. You have verified that the traffic is being forwarded from router leaf L1's VRF-1 to its INSPECT-VRF. However, the traffic is not reaching service L2.

Referring to the exhibit, which two steps should you take to troubleshoot the problem? (choose two.)

• A.Ensure that VRF-1 and INSPECT-VRF route targets on L1 and L2 match.
• B.Examine the INSPECT-VRF.evpn 0 route table on L1 for a default route that will direct the traffic to L2.
• C.Ensure that the route target in the INSPECT-VRF of L1 matches the route target of the INSPECT- VRF of L2.
• D.Examine the INSPECT-VRF.inet. 0 route table on L1 for a default route that will direct the traffic to L2.