JN0-681 試験問題を無料オンラインアクセス

You are configuring an IP Fabric in your data center and you are trying to load-balance traffic across multiple equal-cost BGP routes. You have enabled multipath, but the traffic is not being load-balanced.

Referring to the exhibit, what will solve this problem?

• A.You should apply the load-balance policy as an export policy to the BGP neighbor
• B.You should apply load-balance policy as an import policy to the forwarding table
• C.You should apply the load-balance policy as an export policy to the forwarding table
• D.You should apply the load-balance policy as an export policy for the BGP neighbor

You want to configure redundant Layer 3 gateways
In this scenario, which two juniper best practices would accomplish this task? (Choose two.)

• A.Configuring both IRB interfaces manually with the same IP address
• B.Allowing Junos to dynamically create the virtual MAC address of the IRB interface
• C.Allowing Junos to dynamically create the virtual IP address of the IRB interface
• D.Configuring both IRB interfaces manually with the same address

What is the endpoint of a VXLAN tunnel?

• A.VCF
• B.DLCI
• C.VTEP
• D.LSR

You are asked to enable plug-and-play line card switches in an active VCF without making any future Junos configuration charges. You are also required to ensure that all new line card are automatically upgrade to the correct Junos version without any manual intervention.
In this scenario, which two actions will accomplish this task? (Choose two.)

• A.Set the Virtual Chassis as per-provision before the line are inserted.
• B.Ensure that the newly instead card's MAC addresses are present in the DHCP configuration for ZTP.
• C.Set the virtual Chassis as auto-provisioned before the line cars are inserted.
• D.Configure the auto-sw-update parameter on the VCF before inserting new line cards.

Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP. Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24 network into EBGP. Spine 2 must be configured so that it can load-share traffic destined to the 10 1.1/24 network over both next-hop A and next-hop B.

Which two actions must be performed to accomplish this task? (Choose two.)

• A.Use multihop
• B.Use a load-balancing policy applied to the forward table
• C.Use advertise inactive
• D.Use multipath multipath-As