JN0-360 試験問題を無料オンラインアクセス

How are BGP routes originated?

• A.BGP routes are created using IP subnet definitions at each defined BGP peer.
• B.BGP routes are created using policies associated with BGP peering sessions.
• C.BGP routes are created based on interface subnets used for peering sessions.
• D.BGP routes are created based on all interface subnets on all BGP routers.

Which role does the router ID (RID) have in the BGP route selection process?

• A.The router ID is evaluated immediately after MED to determine route preference
• B.The router ID is evaluated last in the route selection process
• C.The router ID is evaluated after analyzing the IGP metric cost
• D.The router ID is evaluated after the cluster length and a lower router ID is chosen

Which three statements are true about GRE and IP-IP tunnels? (Choose three.)

• A.Tunnel endpoints require a tunnel interface.
• B.Tunnel endpoints must use the loopback interface for reachability.
• C.Tunnel endpoints must have a route to the remote endpoint learned by a dynamic routing protocol.
• D.Tunnel endpoints must have a route that directs traffic into the tunnel.
• E.All intermediary devices must have reachability to the tunnel endpoints.

Click the Exhibit button.


Switch 1 and Switch 2 are configured to run MSTP. However, MSTP is not working.
Referring to the exhibit, which two actions will correct the problem? (Choose two.)

• A.Configure revision-level 2 on Switch 1.
• B.Correct the configuration-name parameter to be identical on both switches.
• C.Configure interface ge-0/0/2 on Switch 2
• D.Correct the bridge-priority parameter to be identical on both switches.

Your customer requests that you provide a transparent Layer 2 service between two of their remote locations. This service must allow them to pass tagged traffic from multiple
VLANs. You decide to use Q-in-Q tunneling on the two provider edge MX Series routers that connect to the customer's CE devices.
Which two statements are true? (Choose two.)

• A.The CE-facing interfaces on the PE devices must be configured as trunk ports.
• B.The CE-facing interfaces on the PE-devices must be configured as access ports.
• C.The PE-facing interfaces on the CE devices must be configured as trunk ports.
• D.The PE-facing interfaces on the CE devices must be configured as access ports.