JN0-347 試験問題を無料オンラインアクセス

Click the Exhibit button. Referring to the exhibit, you are asked to ensure that host-1 can communicate with host-3 while also allowing host-2 to communicate with host-4.
What should you do to enable this behavior?

• A.Use the all keyword when defining the member VLANs for the ge-0/0/1 interface on both Switch-1 and Switch-2.
• B.Configure the native-vlan-id default statement under the ge-0/0/1 port settings on both Switch-1 and Switch-2
• C.Configure the native-vlan-id default statement under the ge-0/0/1 port settings on Switch-1.
• D.Use the all keyword when defining the member VLANs for the ge-0/0/1 interface on Switch-1.

Click to the exhibit button. Referring to the exhibit, which configuration change is needed for an IS-IS Level 1 adjacency between R1 and R2?

• A.Enable Level 2 on R1's ge-0/0/1 interface.
• B.Disable Level 2 on R2'sge-0/0/1 interface.
• C.Configure the Io0 family ISO address 49.0002.0010.0042.0002.00 on R1.
• D.Configure the Io0 family ISO address 49.0002.0010.0042.0002.00 on R2.

Which two statements are correct about redundant trunk groups on EX Series switches? (Choose two.)

• A.Redundant trunk groups load balance traffic across two designated uplink interfaces.
• B.Redundant trunk groups use spanning tree to provide loop-free redundant uplinks.
• C.Layer 2 control traffic is permitted on the secondary link.
• D.If the active link fails, then the secondary link automatically takes over.

Click the Exhibit button. Referring to the exhibit, which type of route is displayed?

• A.martian
• B.aggregate
• C.static
• D.generate.

Click the Exhibit button. Referring to the exhibit, what does the asterisk (*) indicate?

• A.The router originated this entry.
• B.This entry is new.
• C.The router received this entry.
• D.This entry is stale.