JN0-1361 試験問題を無料オンラインアクセス

You are asked to prepare a design proposal for a new enterprise customer. You must ensure that all traffic is routed through and inspected by an SRX Series device located at the corporate headquarters.
In this scenario which solution should be used?

• A.Use a full mesh Layer 3 VPN solution
• B.Use a hub-and-spoke Layer 3 VPN solution
• C.Use a full mesh SD-WAN solution
• D.Use a Junos Fusion Enterprise solution

Your customer wants an MPLS-based L3VPN service between multiple remote locations. Which two statements are true regarding the customer's WAN edge devices? (Choose two )

• A.They must have EBGP configured.
• B.They require IP connectivity with the PEs.
• C.They must have MPLS configured.
• D.They require routes for all remote sites.

Which technology allows a router to continue to forward packets even if the routing protocol adjacencies go down?

• A.graceful restart
• B.graceful Routing Engine switchover
• C.nonstop routing
• D.nonstop bridging

You are asked to provide a proposal for a service provider's OSPF network. The customer is concerned about the volume of link-state advertisements within their network and want to limit this traffic.
Given this scenario which design component would satisfy the customer's requirement?

• A.Use multiple levels.
• B.Use the same AS number.
• C.Use the same router IDs.
• D.Use multiple areas.

Your customer is deploying a large number of Juniper WAN edge devices spread across several remote locations. The customer wants to create an isolated out-of-band management network where these devices can be securely accessed and managed using the CLI and, where possible, the WebUI Which two statements will satisfy the customer's requirements'? (Choose two)

• A.Implement a management configuration group on all WAN edge devices.
• B.Enable the SSH and HTTPS services on each WAN edge device
• C.Ensure the devices are running the FIPS version of the Junos OS.
• D.Place all management interfaces on a common Layer 2 network