C4040-332 試験問題を無料オンラインアクセス

What will allow a customer with PowerHA 6 to enable fast disk takeover in their resource group named rgA?

• A.Use lazy update to convert participating volume groups in rgA to use fast disk takeover.
• B.Ensure that all volume groups participating in rgA are enhanced concurrent capable.
• C.Use C-SPOC to enable fast disk takeover for rg
• D.Ensure that rgA has an Online on All Available Nodes startup policy.

A shared volume group (VG) was created in a PowerHA 7 environment. Given the following example, what must be changed in the VG definition?

• A.Set BB POLICY to relocatable.
• B.Set hot spare characteristics to yes(one to one).
• C.Set concurrent capable to enhanced concurrent.
• D.Set QUORUM to 1(Disabled).

What is the command used to check the status of all interfaces and hearbeats in a PowerHA 7 cluster?

• A.cllsif-p
• B.cltopinfo-m
• C.Iscluster-i
• D.Issrc-Is topsvcs

An administrator has configured a 2-node PowerHA 6 cluster, Node1 and Node2, with no non-IP networks.
Sometime after configuring the cluster, the administrator noticed that Node2 appeared to have been shut down.
After restarting Node2 the administrator analyzed the cluster log files in an attempt to determine the cause of the problem.
The clstrmgr.debug log file contained the following information:

Based on the above information, which of the following could explain why Node2 was shut down?

• A.The node was halted due to a DMS_TIMEOUT.
• B.Node isolation occurred causing a domain merge.
• C.The node was unable to fork a new topology services process due to memory limitations.
• D.Automatic error notification detected a problem and halted the node.

An administrator tries to replace a hot-plug Ethernet adapter using the C-CPOC > Communication Interfaces SMIT menu. When prompted, the administrator selects the incorrect adapter and does not wish to continue. When prompted to confirm adapter replacement, he selects "no".
What is the first action that the administrator must take to restore cluster to the pre-maintenance condition?

• A.Run the drslot command to take the PCI slot out of the "removed" state.
• B.Migrate the resource groups using the adapter back to the node.
• C.Run the cfgmgr command to re-detect the adapter and create the device special files
• D.Run Cluster Verification and Synchronization to reset the adapter state.