C4040-121 試験問題を無料オンラインアクセス

What is the tool used to aid in upgrade planning for interdependencies of HMC and system firmware upgrades?

• A.IBM Fix Level Recommendation Tool
• B.Pre-Upgrade Verification Tool
• C.System Planning Tool
• D.Firmware Validation Tool

When configuring a bridged-virtual-Ethernet-to-physical-Ethernet environment, what value determines which bridge will serve as primary and which as secondary?

• A.Queuing value
• B.Priority value
• C.Class of Service value
• D.Quality of Service value

A POWER7 system has 6 IBM i partitions sharing a single shared processor pool. The system has 3 IBM i operating system licenses. Without exceeding the licenses available, what is the largest allowable value for the "Maximum processing units" setting in the shared processor pool?

• A.3
• B.2
• C.1
• D.6

A Power 720 administrator is going to create a new partition on a machine with 3 existing partitions. The machine has 2 processors in a Shared Processor Pool. The three partitions as defined below for their processor requirements are active, utilizing the Desired processing units.

What is the effect of configuring partition LPAR4 as follows using the same processor pool?

• A.All the partitions in the Shared Processor Pool will have their desired processing units reduced by .1 when LPAR4 is activated.
• B.LPAR4 will start but only receive 0.2 of a processor.
• C.LPAP4 will not start since there is not enough processor capacity to satisfy the minimum.
• D.LPAR4 profile cannot be saved until the maximum is set to 0.8 or less.

How are consoles accessed remotely for AIX and Linux partitions running on an HMC-managed Power Systems server?

• A.In ASMI, select "open shared console" for the desired partition.
• B.Open a ssh connection to the HMC, use the "vtmenu" command.
• C.Telnet to the HMC on port 2301.
• D.Use LAN Console, specifying the appropriate serial and partition number.