A4040-121 試験問題を無料オンラインアクセス

Which of the following is true for the IBM System Planning Tool (SPT)?

• A.SPT can be integrated with IBM i Performance Tools to assist with the sizing of new servers.
• B.Cable and DIMM sizes can be specified to improve implementation efficiency.
• C.SPT can be used to design new partitions or validate the addition of new hardware in existing partitions.
• D.Any system plan can be exported as a configuration file (.CFR) and then imported into the Hardware Management Console or Integrated Virtualization Manager.

A client IBM i partition is being planned. Dual VIO Servers will each provide 40 SAN disks to the client partition, mirrored in IBM i at the adapter level (see example below).

Considering both the host and client partitions, what is the minimum number of vSCSI adapters required to support this disk configuration?

• A.16
• B.6
• C.4
• D.8
• E.12

An administrator is setting up IBM i in Partition 2 of a POWER Blade, in blade slot 9 of a BladeCenter H.
What is used to access the IBM i console during the initial setup of a client IBM i partition?

• A.Telnet to the VIO Server using port 2302.
• B.Sign on to the BladeCenter Advanced Management Module (AMM). Run the AMM command: env -T system: blade[9]:partition[2]>console
• C.Use the BladeCenter Advanced Management Module (AMM) Serial over LAN (SoL) connection to the VIO Server console.
• D.Define a virtual LAN connection in VIO Server from IBM I to an external LAN. Use IBM i LAN console to provide the TCP/IP configuration for the console.

When configuring a bridged-virtual-Ethernet-to-physical-Ethernet environment, what value determines which bridge will serve as primary and which as secondary?

• A.Priority value
• B.Class of Service value
• C.Quality of Service value
• D.Queuing value

An administrator has an IBM i partition hosted by VIO Server (VIOS), and managed by an HMC.
The administrator has hdisk2 through hdiskl7 assigned to a vSCSI adapter, and wants to map 2 more virtual disk units, but receives an error when trying to map the disks to the vSCSI controller.
What is the cause of the error?

• A.The client partition must be powered off to map virtual disks to a vSCSl controller.
• B.The vSCSI adapter limit has been reached.
• C.The disk units are incorrectly formatted for AIX/VIOS.
• D.The PowerVM license must be upgraded to Enterprise from Standard.