H12-831_V1.0-ENU 試験問題を無料オンラインアクセス
| 試験コード: | H12-831_V1.0-ENU |
| 試験名称: | HCIP-Datacom-Advanced Routing & Switching Technology V1.0 |
| 認定資格: | Huawei |
| 無料問題数: | 158 |
| 更新日: | 2025-09-20 |
BGP allows you to use the filter-policy acl-number import command to filter received routes. The value of ad- number ranges from 2000 to 3999.
On the OSPF network shown in the figure, R1 and R2 use OSPF to communicate with each other through Loopback0. In addition:
* MPLS LDP is enabled on R1 and R2.
* The LDP transport address is the IP address of Loopback0.
* A network engineer finds that an LDP session cannot be established between R1 and R2 and runs diagnostic commands (shown in the figure) to locate the fault.
Given this, which of the following are possible causes of the fault?
Options:
A network engineer provides a troubleshooting report after rectifying a fault. The actual network is simplified into the one shown in the figure, where R1 and R2 both have OSPF enabled and function as the gateways of PC1 and PC2, respectively.
Given this, which of the following statements are true?
Network Topology:
* R1:
* Interface GE0/0/0: 10.0.12.1/24 (Connected to R2)
* Interface GE0/0/1: 192.168.1.1/24 (Gateway for PC1)
R2:
* Interface GE0/0/0: 10.0.12.2/24 (Connected to R1)
* Interface GE0/0/1: 192.168.1.2/24 (Gateway for PC2)
Options:
On the network shown in the figure, the DHCP server function is enabled on GEO/0/0 of R2, and the address pool is an interface address pool. When GEO/0/0 and GEO/0/1 of R1 function as DHCP clients, only one interface can obtain an IP address by default.
On the network shown in the figure, single-hop BFD is configured on R1 and R2.
A network engineer finds that the BFD session goes down. To locate the fault, the network engineer queries the BFD configurations on R1 and R2.
According to the configuration information marked in the figure, it can be determined that mismatched time parameter settings on R1 and R2 cause the BFD session to go down.
Is this statement TRUE or FALSE?