HPE7-S01 試験問題を無料オンラインアクセス

An HPE Synergy customer is expanding from one frame to seven frames and wants to minimize the number of interconnect modules and uplink ports required.
Which design should you recommend?

• A.Master Virtual Connect modules in two frames with satellite modules in the remaining frames
• B.Pass-through modules in all frames connected to top-of-rack switches
• C.Direct-attach SAS interconnects in each frame with shared uplinks
• D.A pair of Virtual Connect modules in every frame, each with its own uplinks

A customer wants you to design a solution for effectively near 100% liquid cooling for their HPE Cray XD systems.
Which solution should you propose?

• A.Closed-loop liquid cooling for the HPE Cray XD Systems plus an HPE ARCS
• B.70% DLC plus a closed-loop liquid cooling system for the HPE Cray XD Systems
• C.70% DLC for the HPE Cray XD systems plus an HPE RDHX
• D.100% DLC for the HPE Cray XD systems

A customer runs latency-sensitive network functions in virtual machines and reports that the hypervisor virtual switch adds unacceptable overhead.
What should you recommend?

• A.Move the virtual machines to a dedicated port group with NIC teaming
• B.Increase the number of vCPUs assigned to each virtual machine
• C.Enable SR-IOV and assign virtual functions directly to the virtual machines
• D.Enable jumbo frames on the virtual switch uplinks

A customer's security policy requires that all management traffic use only approved cryptographic algorithms and that firmware downgrades be blocked on their ProLiant servers.
What should you recommend?

• A.Configure iLO directory integration with Kerberos authentication
• B.Disable the iLO dedicated network port and use the shared host port with VLAN tagging
• C.Enable UEFI Secure Boot and set an administrator password
• D.Set the iLO security state to High Security or higher and enable the server configuration lock

You are creating a proposal for HPE ProLiant DL servers to act as VMware ESXi hosts.
How does a customer requirement to support Fault Tolerance (FT) affect your plan?

• A.You must ensure that the servers' processors are compatible with SMP-FT.
• B.You must ensure that the servers' adapters are RoCEv2 capable.
• C.You must ensure that the servers' storage controllers are compatible with SMP-FT.
• D.You must ensure that the servers have sufficient memory to reserve 20% for FT.