HPE7-A07 試験問題を無料オンラインアクセス

A customer is installing CX 6300 switches, mobility gateways, and AP-635s.
The customer's VoIP system uses both wired and wireless handsets.
The handsets are configured to mark voice traffic using a DSCP value of 46.
The wireless handsets connect to a bridged SSID using WPA3-SAE.
What will allow the switch to honor the QoS mark set by the handset?

• A.Enable QoS trust DSCP
• B.Activate UCC for the HPE Aruba Networking Central Group managing the APs
• C.Enable WMM on the voice SSID
• D.Configure Voice Wi-Fi Multimedia Share for DSCP 46 on the voice SSID

An ACME company employee complained about a recent poor-quality VoIP call while moving around their office environment HPE Aruba Networking Central reported a fair UCC score for this call while your VoIP engineer reported that their systems reported a MOS of 2, 3. The VoIP devices are operating over the 5GHz frequency band.
What are the possible contributing factors? (Select two.)

• A.802.1K is disabled in the WLAN Security settings
• B.Coverage AP deployment plans generally don't support enough cell overlap for VoIP.
• C.There was localized interference at the caller's location
• D.The client roamed into an area that continuously operates Zigbee.
• E.802.tr is enabled in the WLAN Security settings.

Exhibit.

What is me expected behavior for ARP traffic sent from H1?

• A.A2 will send the ARP traffic out of ports 1/1/1 and 1/1/3.
• B.A2 will send the ARP traffic out of ports 1/1/1-1/1/4.
• C.A2 will flood the ARP traffic out of all interfaces.
• D.A2 will drop the ARP traffic.

A customer would like to allow their IT Helpdesk to configure IoT devices to connect to a single SSID using a unique PSK that other devices cannot use.
Which solution would you recommend?

• A.MPSK Local
• B.MPSK AES with HPE Aruba Networking Central Cloud Authentication
• C.MPSK AES with MAC Auth
• D.MPSK AES with HPE Aruba Networking ClearPass

You are troubleshooting a WLAN deployment with APs and gateways set up with an 802.1X tunneled SSID.
End-users are complaining that they can't connect to the enterprise SSID. Which possible AP tunnel states could be the cause of the issue? (Select two.)

• A.SM_STATE_CONNECTING
• B.SM_STATE_CONNECTED
• C.SM_STATE_SURVIVED
• D.SM_STATE_REKEYING
• E.SM_STATE_SURVIVING