HPE6-A86 試験問題を無料オンラインアクセス

While investigating a fault, you discovered that a LAG interface from an aggregation switch was connected to two different access switches.
How can you re-configure the LAG interface so it will only come up if connected to the same access switch?

• A.Change the hash algorithm.
• B.Enable LLDP on both switches.
• C.Configure a dynamic lag.
• D.Configure a static lag.

What are valid responses from a RADIUS server? (Choose two.)

• A.PERMIT
• B.ALLOW
• C.ACCEPT
• D.BLOCK
• E.DENY
• F.REJECT

Your colleague is installing a new HPE Aruba Networking CX 8100 switch in a data center in the default configuration. You monitor the peer switch port 1/1/1 status, connected with a 10Gb 3m DAC cable to the new switch, and validate that the cable is attached. The port remains down.
What should you suggest your colleague do so the port can come online?

• A.Request to issue command: switching enable on the port DAC cable is connected to.
• B.Request to swap the DAC cable between the switches for correct Tx/Rx alignment.
• C.Request to issue command: no shutdown on the port DAC cable is connected to.
• D.Request to move the DAC cable to another port on the CX 8100 switch.

A customer is planning a replacement of their current 2930F switches, which are configured using VSF stacking. The proposed switches are CX 6200 models. What is the key difference between the stacking features of the current and proposed solutions?

• A.The primary member always uses ID 1.
• B.The VSF feature is disabled by default.
• C.The VSF MAD is enabled by default on each LAG when LACP active is set.
• D.The VSF member count is higher.

Which is at the Transport Layer of the OSI model?

• A.IP Address
• B.TCP Port
• C.MAC Address
• D.Switch Port