HPE6-A75 試験問題を無料オンラインアクセス

An administrator implements a standalone controller that runs ArubaOS 8.x. Which feature should the administrator configure to optimize the RF operation for the company's WLAN?

• A.Zones
• B.Clustering
• C.AirMatch
• D.ARM

Refer to the exhibit.

Controllers are configured m a cluster as shown in the exhibit. These are the network details.
- A Mobility Master (MM) manages the cluster.
- The cluster contains two controllers: Cl and C2.
- API and AP2 use C1 as their Active AP Anchor Controller (A-AAC) with
C2 as their Standby AAC (S-AAC).
- AP3 and AP4 use C2 as their A-AAC, with C1 as their S-AAC.
User1 establishes a wireless connection via API, where the Active User Anchor Controller (A- UAC) assigned is C1, with C2 as the standby. What happens when User1 roams the wireless network and eventually their session is handled by AP3?

• A.The AP3's A-AAC switches to C1, and the user's A-UAC remains on C1.
• B.The AP3's A-AAC switches to C2, and the user's A-UAC remains on C1.
• C.The AP3's A-AAC switches to C1, and the user's A-UAC remains on C2.
• D.The AP3's A-AAC switches to C2, and the user's A-UAC remains on C2.

Refer to the exhibit.

Based on the Attribute configuration shown, which statement accurately describes the status of attribute values?

• A.Only the attribute values of title, telephoneNumber, and mail can be used in role mapping policies.
• B.The attribute values of department, title, memberOf, telephoneNumber, and mail are directly applied as ClearPass.
• C.The attribute values of department and memberOf are directly applied as ClearPass roles.
• D.Only the attribute value of company can be used in role mapping policies, not the other attributes.
• E.Only the attribute values of department and memberOf can be used in role mapping policies.

An administrator supports a cluster of four Aruba Mobility Controllers (MCs) with management addresses of 10.1.100.101, 10.1.100.102, 10.1.100.103, and 10.1.202.181. The administrator accesses an AP associated with this cluster, reboots it and accesses apboot mode. The administrator executes the printenv command. Which AP parameter contains the IP addresses of the cluster members that the AP should use to connect to the cluster?

• A.Master_ip
• B.Noodelist
• C.Servername
• D.Cfg_lms

An AOS-Switch enforces 802.1X authentication to an Aruba ClearPass server. A user connects but cannot receive network access, even though the ClearPass administrator finds an Access- Accept for the user on this switch. The switch administrator suspects that there is an issue with the dynamic settings returned by ClearPass.
Where should the administrator look for information about these settings?

• A.in the details for port-access clients
• B.in the running-config for the interface
• C.in the detailed RADIUS server statistics
• D.in the interface statistics