HPE6-A48 試験問題を無料オンラインアクセス
| 試験コード: | HPE6-A48 |
| 試験名称: | Aruba Certified Mobility Expert Written Exam |
| 認定資格: | HP |
| 無料問題数: | 75 |
| 更新日: | 2026-06-10 |
Refer to the exhibit.
After a recent power outage where MM1 is located, the network administrator could not perform configuration tasks on Mobility Controllers (MC) for several hours.
The network administrator decides to acquire another Mobility Master (MM) and deploy L2 MM redundancy. The new MM is assigned the 10.254.10.15 IP address and VRRP is configured in both units. The network administrator verifies that VRRP is running, and prepares to complete the setup with the following scripts.
Which configuration tasks must the network administrator do before applying the script in order to successfully deploy L2 MM redundancy and prevent any other control plane outage?
Refer to the exhibits.
Exhibit 1
Exhibit 2
Exhibit 3
A network administrator must ensure that a ClearPass server can receive the RADIUS authentication request from a single Mobility Controller (MC) managed by a Mobility Master (MM). Based on the exhibits, what is the value of NAS-IP contained in the RADIUS access requests?
A network administrator needs to deploy L2 Mobility Master (MM) redundancy. MM1 uses IP address 10.201.0.10 and MAC address 1c:98:ec:25:48:50, and MM2 uses IP address 10.201.0.20 and MAC 1c:98:ec:99:8a:80. Both run VRRP process with VRID 201.
Which configuration should the network administrator use to accomplish this task?
Refer to the exhibits.
Exhibit 1
Exhibit 2
A network administrator deploys role-based tunneled node in a corporate network to unify the security policies enforcement. When users authenticate with 802.1X, ClearPass shows Accept results, and sends the HPE-User-Role attribute as expected. However, the switch always applies the denyall role.
Why does the switch fail to allocate the tunnel-employee role?
Refer to the exhibits.
Exhibit 1
Exhibit 2
Exhibit 3
A network administrator deploys a Mobility Master (MM) pair with the VRRP VIP equal to 10.254.10.214, and attempts to associate MC1 to it. At first, the integration appears to be successful. However after a few minutes the network administrator issues the show switches command and sees that the MC1 is down, even though the device is up and running.
Every time the network administrator reboots the Mobility Controller (MC), the MC shows as being up and then it shows as being down. The network administrator gathers the information shown in the exhibits.
What should the network administrator do to resolve this problem?