HPE2-W09 試験問題を無料オンラインアクセス

Refer to the exhibits. Is this how the switch-1 handles the traffic?


Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10. except the incoming interface. It replicates the broadcast, encapsulates each broadcast with VXLAN. and sends the VXLAN traffic to 192.168.1.2 and
192.168.1.3.

• A.Yes
• B.No

You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Idle, which means that the ring is up and fully connected with the RPL port blocked.

• A.Yes
• B.No

Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?
Solution: connecting multiple data centers at Layer 2 while minimizing the number of dark fiber connections required

• A.Yes
• B.No

Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: IPv6 protocol can be encapsulated in the underlay network's IPv4 packets.

• A.Yes
• B.No

You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Create a conformance validation test to deploy the standard part of the configuration.

• A.Yes
• B.No