HPE0-Y53 試験問題を無料オンラインアクセス

Refer to the exhibits on the Exhibit 1 and Exhibit 2 tabs.

Exhibit 2 Network clients are configured to use the switch as their default gateway in VLAN 2. The HP Comware switch places VLAN 2 in OpenFlow instance 1. An SDN application has created the flow entry shown in Exhibit 1 to route traffic from 10.1.2.0/24 to 10.1.3.0/24. Exhibit 1 does not show the output interface for the flow.

Which output interface supports the needs of this scenario?

• A.controller
• B.ANY
• C.TABLE
• D.NORMAL

A company is using MCE to create a multi-tenant data center solution. Network administrators want to isolate all management functions in a VPN instance "Management". Each switch has an IP address in 10.0.2.0/24 on its Management Ethernet port, and HP IMC manages the switches on these IP addresses. Administrators assign the Management Ethernet interfaces to the "Management" VPN instance. IMC begins losing data from the switches.
How should administrators fix the problem on each switch?

• A.Set VPN instance "Management" as the default VPN instance.
• B.specify VPN instance "Management" for management settings such as SNMP trap destination.
• C.Enable route leaking globally.
• D.Create a static or dynamic route to 10.0.2.0/24 in the public VPN table.

A company wants to authenticate communications between SDN applications and the HP VAN SDN Controller using the company's existing network authentication server. What is one of the components that the authentication server requires to authenticate these applications?

• A.X-Auth-Token
• B.Terminal Access Controller Access-Control System (TACACS)
• C.LDAP Pluggable Authentication Modules (PAM)
• D.RADIUS protocol

A switch is configured with four OpenFlow tables: Table 0, Table 50, Table 100, and Table
200. Which table will reject the go-to-table action in its flows?

• A.Table 100
• B.Table 0
• C.Table50
• D.Table 200

Refer to Exhibit:

A network administrator wants to create a leaf and spine topology. How should the administrator connect the switches for the best latency and load-balancing?

• A.Connect each leaf switch to each spine switch, and run a protocol such as TRILL.
• B.Connect each leaf switch to each spine switch, and run a protocol such as EVI.
• C.Connect each leaf switch to half of the spine switches, and run a protocol such as TRILL.
• D.Connect each leaf switch to half of the spine switches, and run a protocol such as EVI.