HP2-Z37 試験問題を無料オンラインアクセス

When do the members in an existing Intelligent Resilient Framework (IRF) virtual device have a master election?

• A.when a slave member is removed from the IRF virtual device
• B.when an IRF merge occurs
• C.when the switch software is updated using In-Service Software Update (ISSU)
• D.when a slave member fails or loses connectivity

Refer to the exhibit.

A network administrator needs to upload a software image of 21,240 KBs to an HP Comware switch. Theadministrator checks the flash and sees the output in Exhibit 1. The administrator then deletes the a5800_5820x-cmw520-r1211p09.bin file. The administrator checks the flash again and sees the output in Exhibit 2.
What should the administrator do to prepare to upload the new software image?

• A.Clear the recycle bin.
• B.Configure the switch to boot to the BootROM mode and then load the software from that mode.
• C.Copy the software to the primary or secondary slot, which is separate from the normal switch flash.
• D.Reboot the switch.

Refer to the exhibits.

Exhibit 1 shows some of the discovery settings on HP intelligent Management Center (IMC). Exhibit 2 shows part of the running-config on an HPComware switch.
What shouldthe network administrator do to ensure that IMC can correctly configure this Comwareswitch?

• A.Configure private and public keys for Telnet on the Comware switch.
• B.Configure password authentication mode and a password on the Comware VTY 0-15 interfaces.
• C.Configure scheme authentication mode on the Comware AUX 0 interface
• D.Change the IMC settings to use the default username, admin, and default password, admin

Refer to the exhibit.

The link aggregation is failing between the HP Provision and HP Comware switches. Which solution solves this problem?

• A.removing the ProVision interfaces from trk10 and assigning them to trk1 instead
• B.removing the VLAN assignment from the Comware bridge aggregation interface and configuring the assignment on the physical interfaces
• C.configuring the Comware switch to use dynamic link-aggregation mode on the bridge aggregation interface
• D.configuring contiguous interfaces, such as 10 and 11, in the ProVision link aggregation (trk 10)

Refer to the exhibit.

A network administrator has created an HP Intelligent Resilient Framework (IRF) device with two members. The members are connected on two interfaces, which are assigned to one IRF port on each member. The administrator enters the command shown in the exhibit.
What does the output indicate?

• A.The two members are not connected at Layer 2 on the links assigned to the IRF ports.
• B.The two members are only connected on one of the interfaces, so the IRF link cannot be established.
• C.The two members are connected correctly, and the IRF link between them is up.
• D.The two members are connected at Layer 2 on the links assigned to the IRF ports, but the IRF link cannot be established.