HP2-Z30 試験問題を無料オンラインアクセス

What is the console port designation for an HP Comware switch?

• A.con 0
• B.aux 0
• C.interface console
• D.console

A network administrator has an HP Comware switch that is configured with OSPF. The network administrator views the routing table and sees that a default route was learned from an OSPF neighbor (10.1.1.1). However, the network administrator wants to override this action and use a different neighbor (10.1.1 2) for the default route.
The network administrator configures this command:
[Comware] ip route-static 0.0.0.0 0 10.1.1.2
After configuring the command, the network administrator examines the routing table and notices that the original neighbor's default route is still in the routing table, but the static route is missing.
What is the cause of this problem?

• A.Only one routing protocol can be operational on a Comware device
• B.The static route has a syntax mistake
• C.The ip default-gateway command must be used when creating a default route
• D.OSPF routes have a lower precedence value

Which statement is correct about IRF?

• A.Logical IRF port one on a switch must be connected to IRF port two on a second switch.
• B.Identical models of switches must be used in the same IRF domain.
• C.MSTP is used to remove loops within an IRF domain.
• D.LACP is used to build IRF port connections between switches.

Which URL can a network administrator use to access Intelligent Management Center (IMC)?

• A.http://<ip-address> | <hostname>:8080/imc
• B.http://<ip-address> | <hostname>:8000
• C.http://<ip-address> | <hostname>:8043
• D.http://<ip-address> | <hostname>

Refer to the exhibit.

A network administrator needs to configure link aggregation using static LACP on Switch-A, which is an HP Comware switch. Which configuration accomplishes this goal?

• A.Option D
• B.Option C
• C.Option A
• D.Option B